Fatigue Life Evaluation on Compressive & Tensional Residual Stress Induced Materials and Residual Stress Measurement using Hole Drilling Method

Baek, Seung Yeb

doi:2013.31.2.43

J Weld Join > Volume 31(2); 2013 > Article

Research Paper

Journal of KWJS 2013;31(2):43-48.
DOI: https://doi.org/10.5781/KWJS.2013.31.2.43 Published online June 5, 2013.

Fatigue Life Evaluation on Compressive & Tensional Residual Stress Induced Materials and Residual Stress Measurement using Hole Drilling Method

Seung Yeb Baek

Correspondence: Seung Yeb Baek,
Email: sandos@hanmail.net

Abstract

This paper Investigated the characteristics of residual stress in weld is composed of typical specimens, are investigated by using three dimensional thermal elasto-plastic FEM analysis. Numerically calculated residual stresses in the gas welds were then compared with experimental results obtained by the hole-drilling method. Using the stress amplitude (σa)R at the hot spot point of gas weld, the relations obtained as the fatigue test results for typical specimens having various dimensions and shapes were systematically rearranged to obtain the (σa)R-Nf relationship. It was found that more systematic and accurate evaluation of the fatigue strength of plug- and ring-type gas-welded joints can be achieved by using (σa)R.v

Key Words: Residual stress, Fatigue design criterion, Thermal stress, Hole drilling method